- Messages
- 10,198
Code:
[B]Application: [/B]
-all the files in this archive to a FAT32-formatted USB-stick into the directory / kathrein/ufs922 copy, keep intact all the filenames
Receiver on / off power switch
-the prepared USB stick stuck to the receiver, remove all other USB devices safe
behind the front panel to press the "REC" touch and hold
-Turn power switch off
-after about 1 to 2 seconds, the display of the text "[] / UP2/TE2/OPT"
-now release the "REC" button and briefly press the button <Stop>, from now on, please sit back and zuschaun :-)
-now appear in the display a series of messages:
flash update
loading image ...
erase wait 3 min
-Flash is erased, takes about 2 minutes
flash wait 6 min
will describe the flash with the new image takes about 6 minutes
ready to go
now the box-an automatic reset and start with the newly-established software makes
-complete, the USB stick can be removed
Have this procedure works with all flash image to the right size of 15.8 MB
Even the "drüberflashen" Softwarerev same work (the original emergency is preventing Kathrein)
[B]Notes:[/B]
-there are no connections (network, serial port ...) between your PC and box needed
-the bootargs, or bootenvironment variables are set by this procedure on Enigma2 defaults:
ipaddr 192.168.1.100
serverip 192.168.1.1
GatewayIP 192.168.1.1
netmask 255.255.255.0
bootargs = 'console = ttyAS0, 115200 root = / dev/mtdblock2 kathrein ip = $ (ipaddr): $ (serverip): $ (GatewayIP): $ (netmask):: eth0: off
mem = 89m init = / bin / devinit coprocessor_mem = 4m @ 0x10000000, 4m @ 0x10400000 '
OTHERS WHO IPADDR (IP) GATEWAY (GW) ... ETC. USES:
PLEASE IN THIS PRELIMINARY UPDATESCRIPT.SH WITH UNIX ELIGIBLE TO EDITOR Notepad2 OR PSPad Customize!
If this script-used for other images is that different bootargs need (for example, from the original on E2, or vice versa),
bootargs be the serial console or directly in the script adjusted accordingly (must read the appropriate readme images!)
-This readme file contains the very top of the CRC32 checksum of the images attached to E2
-flashed if not, the attached E2-image but another will then be
the readme of the image of the corresponding CRC32 checksum included.
-Who gets the flash process followed a COMterminal at the end of flash process appears twice a CRC32 checksum
-both of you! Ads must match the checksum of the image flashed, then everything was ok
-when the first ad false and the second display is correct, then the flash of your box is broken!
has when both ads are false, then the transfer from the USB stick is not working properly test ---> another stick