Just tried the update to V2 on my Solo 2 Clone,
The USB FPGA update went fine, however the .dat part seems to have issues.
as per the instruction I opened the update.exe and switched on the solo2 and got the correct
"start download..." compliance -
However there were no dots or indication that the update was actually sent to the box.
The cable used had the following pinout -
Plug no 1 Plug no 2
2 ------------- 1
5 ------------- 5
3 ------------- 6
The cable is detected due to update.exe starting the download when the solo starts.
Any help appreciated.
The USB FPGA update went fine, however the .dat part seems to have issues.
as per the instruction I opened the update.exe and switched on the solo2 and got the correct
"start download..." compliance -
However there were no dots or indication that the update was actually sent to the box.
The cable used had the following pinout -
Plug no 1 Plug no 2
2 ------------- 1
5 ------------- 5
3 ------------- 6
The cable is detected due to update.exe starting the download when the solo starts.
Any help appreciated.