OScam x86_64-PC-Linux

05.05.2013 Oscam1.20 svn8641

- Changeset [8641] by depp0n
- implemented PPS for coolstream internal reader
- Changeset [8640] by theparasol
- Loadbalancer rework by Blueven Report issues in forum or this ticket:
streamboard.tv/oscam/ticket/2682
- Changeset [8639] by theparasol
Revert part of 8637 (see ticket 3307)
- Changeset [8638] by theparasol
Poll() could be interrupted-> the timeout should be lowered with time lost due to interrupt
- Changeset [8637] by theparasol
- Rework of poll() to reduce cpu load
- Additional logging output of events
Tnx to braini666 for testing and reporting (cpuload dropped from 21.4% to 16.1%)
Hope it doesnt break anything, if so plz report issues in forum!

thanks LePouSAT

Oscam1.20 svn8642

- Changeset [8642] by docman
Added 'lb_nbest_readers' and '_nbest_readers_tab' to 'oscam.user' documentation.
Removed 'lb_reopen_mode' from documentation.

thanks LePouSAT

13.05.2013 Oscam1.20 svn8643

- Changeset [8643] by theparasol
- Enhanced the ratelimiter ecmunique with odd/even cycle check

thanks LePouSAT

Oscam1.20 svn8648

- Changeset [8648] by theparasol
- Loadbalancer fix for lb_value=0 problem tnx Blueven for providing patch
- Changeset [8647] by theparasol
- Init ecm rc status to E_UNHANDLED

thanks LePouSAT

Oscam1.20 svn8658

- Changeset [8658] by theparasol
- More fix for radegast protocol tnx goodsat for patch
- Changeset [8657] by theparasol
- Fix for connection timeout after EMM is send over cs378x
Tnx to skyjet for patch
- Changeset [8656] by theparasol
- Revert 8655 (loadbalancer knocking failed srvids on readers once)
Add new parameter in reader setup lb_whitelist_service
tnx to Blueven for providing patch

thanks LePouSAT

Oscam1.20 svn8667

- Changeset [8667] by bowman
Fixed debug logging that wasn't platform independent
- Changeset [8666] by bowman
Completed support for incoming udp cache updates from csp
and added experimental outgoing push (untested)
- Changeset [8665] by Eggy123
a) Fixed bug in hello logic: start counting card number at 0 again after hello packet send
b) Switch to next state only after last packet

thanks gianni8127

Oscam1.20 svn8668

- Changeset [8668] by bowman
Skip push to csp if source is remote cacheex for now (might cause loops).
Added sending of cache pings.

thanks LePouSAT

Oscam1.20 svn8669

- Changeset [8669] by bowman
Added the last request type used by csp clusteredcache and cleaned things up a bit.
Further discussion/testing needed proceed.

thanks LePouSAT

Oscam1.20 svn8675

- Changeset [8675] by docman
Documentation update for 'ecmfmt': new option ONID.

- Changeset [8674] by docman
Documentation update for CSP: TCP -> UDP.

- Changeset [8673] by docman
Added new parameter 'lb_nfb_readers' to 'oscam.user', now TXT and HTML Format, too.

- Changeset [8672] by docman
Added new parameter 'lb_nfb_readers' to 'oscam.user'.

- Changeset [8671] by docman
Documentation update for gbox port definitions.

- Changeset [8670] by manio
cosmetics: fix MHz spelling Hertz is a unit from SI and need to preserve a correct case (​en.wikipedia.org/wiki/SI_derived_unit)

thanks LePouSAT

06.06.2013 Oscam1.20 svn8684

- Changeset [8684] by docman
Updated documentation for gbox TCP -> UDP.
- Changeset [8683] by docman
Removed 'decodeforever' from documentation.
- Changeset [8682] by theparasol
- Tryfix azbox support - Fix dvbapi part on latest code analysis posted by Gorgone

thanks LePouSAT

20.06.2013 Oscam1.20 svn8705

- Changeset [8705] by stefansat
Same rules off 6a do apply for 6c and 6d
This avoids a lot off fake or non working ecm to 6c and 6d card's

thanks LePouSAT

Oscam1.20 svn8721

- Changeset [8721] by goodsat
Patch long ecm size ecm max + header max newcamd 12
- Changeset [8720] by lattjo
Re-arranged some variabels.
Saves a few bytes of memory for each reader if compiling without cardreaders.
-Changeset [8719] by lattjo
smargo: Implement set_parity to make sure correct parity is set after ATR is read.
- Changeset [8718] by lattjo
smargo: Some more cleanup

thanks LePouSAT

Oscam1.20 svn8749

- Changeset [8749] by bowman
Finalized ghttp autoconf.
-Changeset [8748] by theparasol
Dump work in progress on dvbapi modules
Fixed chid prio without force
Restored channelcache chid I removed before
Channelcache chid now overrules oscam.dvbapi prio chid
Pids without status / prio start in second descramble run, not in first
Tryfix stapi starting up streamfilters in standby
- Changeset [8747] by bowman
Work in progress: Added an autoconfig page for ghttp to the webif.

thanks LePouSAT

19.07.2013 Oscam1.20 svn8758

- Changeset [8758] by stefansat
added nagra chid info
this info is correct for all nagra/seca based cards when using the nagra pid
- Changeset [8757] by lattjo
Cryptoworks: Fixed spelling error in log
- Changeset [8756] by docman
Update documentation for penalty: disable to ban.

thanks LePouSAT

24.07.2013 Oscam1.20 svn8767

- Changeset [8767] by stefansat
changed lb into the loadbalancer

thanks LePouSAT

05.08.2013 Oscam1.20 svn8816

- Changeset [8816] by gorgone.impertinence
fix footer link
- Changeset [8815] by gorgone.impertinence
fix rederstats menu
- Changeset [8814] by gorgone.impertinence
restore modern webif first release no optimisations !!!
- Changeset [8813] by gorgone.impertinence
firs clean

thanks LePouSAT

oscam-svn8858-x86_64-pc-linux-webif-libusb-ssl-Distribution.tar.gz
:thum:

oscam-svn8870:thum::thum::thum::thum:

oscam-svn9063-x86_64-pc-linux-webif-Distribution.tar.gz


oscam-svn9063-x86_64-pc-linux-webif-libusb-Distribution.tar.gz


oscam-svn9063-x86_64-pc-linux-webif-libusb-ssl-Distribution.tar.gz