reed switch
- Thread starter Car123
- Start date
- Messages
- 887
Just in case the post above does not make sense it is a continuation of this thread,
www.sat-universe.com
dish stopi ng at each satllite from e to west
dish stoping ok at each satlliten from the E but dose not stop coming from the W any boday any ideas why its doing this im using a vbox and a 12 inch motor jack
www.sat-universe.com
- Messages
- 17,502
If constantly blowing, it suggests it is not just a one off issue but there is an underlying cause
Operator error, wiring up the motor cables to the reed switch connections is a common cause.
Or it could be issues with the equipment. There are only two pieces of equipment though, a positioner, often a v-box and the 36V motor.
- Messages
- 887
How can moonbase say its the jack when he has no hands on experience of your equipment, he is giving his opinion on what it could be. You need to test your equipment but how you test you type of equipment i'm unsure. Maybe test the motor to see if its going short circuit. I'm guessing there should be no continuity between cable in and casing of the motor.
Why dont you check your posts before making them.
Nobody is going to reply with help to this type of post, it's just garbage.