- Neutrino_ufs922_flash_236-RC2
UFS 922 Flash Pack by solala
Content:
- miniFLASH.img
- updatescript.sh
- readme
- Application:
- -all the files in this archive to a FAT32-formatted USB-stick into the directory / kathrein/ufs922 copy, keep intact all the filenames
- Receiver on / off power switch
- -the prepared USB stick stuck to the receiver, remove all other USB devices safe
- behind the front panel to press the "REC" touch and hold
- -Turn power switch off
- -after about 1 to 2 seconds, the display of the text "[] / UP2/TE2/OPT"
- -now release the "REC" button and briefly press the button <Stop>, from now on, please sit back and zuschaun
- -now appear in the display a series of messages:
- flash update
- loading image ...
- erase wait 3 min
- -Flash is erased, takes about 2 minutes
- flash wait 6 min
- will describe the flash with the new image takes about 6 minutes
- ready to go
- now the box-an automatic reset and start with the newly-established software makes
- -complete, the USB stick can be removed
- Have this procedure works with all flash image to the right size of 15.8 MB
- Even the "drüberflashen" Softwarerev same work (the original emergency is preventing Kathrein)
- Notes:
- -there are no connections (network, serial port ...) between your PC and box needed
- -the bootargs, or bootenvironment variables are set by this procedure on Enigma2 defaults:
- ipaddr 192.168.1.100
- serverip 192.168.1.1
- GatewayIP 192.168.1.1
- netmask 255.255.255.0
- bootargs = 'console = ttyAS0, 115200 root = / dev/mtdblock2 kathrein ip = $ (ipaddr): $ (serverip): $ (GatewayIP): $ (netmask):: eth0: off
- mem = 89m init = / bin / 4m = devinit coprocessor_mem @ 0x10000000, 4m @ 0x10400000 '
- OTHERS WHO IPADDR (IP) GATEWAY (GW) ... ETC. USES:
- PLEASE IN THIS PRELIMINARY UPDATESCRIPT.SH WITH UNIX ELIGIBLE TO EDITOR Notepad2 OR PSPad Customize!
- If this script-used for other images is that different bootargs need (for example, from the original on E2, or vice versa),
- bootargs be the serial console or directly in the script adjusted accordingly (must read the appropriate readme images!)
- -This readme file contains the very top of the CRC32 checksum of the images attached to E2
- -flashed if not, the attached E2-image but another will then be
- the readme of the image of the corresponding CRC32 checksum included.
- -Who gets the flash process followed a COMterminal at the end of flash process appears twice a CRC32 checksum
- -both of you! Ads must match the checksum of the image flashed, then everything was ok
- -when the first ad false and the second display is correct, then the flash of your box is broken!
- has when both ads are false, then the transfer from the USB stick is not working properly test ---> another stick
evt for questions:
Solala
