I did install oscam emu 11391 .all the ecm is found But video I freezes at about 20 minutes intervals.
My reader config is below.
Reader
[reader]
label = D
enable = 1
protocol = cccam
device = xxxxx*
user = xxxx
password = xxxx
group = 1
cccversion = 2.0.11
disablecrccws_only_f*or =...
Hi
Emp centurie S8/1PCP-W2 switch
I have connect monoblock to 8×1 switch
My configuration for monoblock connect with power pass splitter
Output from power pass splitter is connected to 5 th and 6 th ports of DiseqC switch
Configuration Mode: Advanced
Satelitte: sat1
LNB: Lnb5
Priority: Auto...
Hi
Emp centurie S8/1PCP-W2 switch
I have connect monoblock to 8×1 switch
problem is most of the times sat2 not working on monoblock sometime works. other sat1 on monoblock always works
single lnb works good
When sat1 works if I change to any other sat and switch back to sat1 again it is not...
Hi there
My duo2 can't scan following transponder of St 2 88e
11483H,V AND 11546H.11672H
Snr for all is well above 80%
Then I did merge lamedb. File from vu + zero from mu friend. Then following message is common when I open new channels added.
no data on transponder timeout reading pat and sid...
I see in forum that cccam+ some other emulator file .what is the difference only cccam and install with another emu
And also what is emu key receiving by c line