Code:
[B]How to do auto-update with ITGATE Control Center[/B]
New Control center must be used from now on.(from ver.2.4)
1) Download and Unzip the file below.
2) Run the ITGATE Control Center.
3) Insert & save IP address in the 'Config' section.
4) Press 'Update' button & select the *.img file in the 'Update' section.
5) Autoupdate will be started.
6) Wait until the receiver reboots automatically
[B]How to update TGS 220 by Flashing through serial port[/B]
New Control center must be used from now on.(from ver.2.4)
1) For Serial update, please click hereunder to download the image.
1. Connect the receiver & PC with RS 232 cable
2. Power on the receiver & press CH+ button
on the front at the same time repeatedly.
3. You will see the menu,in which there is 'Serial Update'
& go to the menu using by CH+/- button.
4. When you cursor located on 'Serial update', press vol+ button
& Press CH- button to start the upgrade.
-----------------------------------------------------
Before the above no.4,
1. run the control centre & go to the 'Serial update'
section (you don't need to input IP address)
2. After setup the com port, press 'file' & select the img.file.
After that, you can start the serial update under the above no.4
[B]How to update by Internet[/B]
1) Press MENU button on the remote controller and go into " Setup -> Expert
Setup -> Software Update -> Internet Update" and select the image.
2) Follow as prompted on the menu..
[B]How to update TGS220 with USB Memory stick automatically[/B]
1) Copy all below files(after unzip) inside folder to the USB stick(FAT/FAT32).
2) Switch off the receiver and insert the memory
stick into the USB slot on the rear panel.
3) Switch on the receiver.
4) Soon after, you can see downloading process by number(1~100)
on LED display. Please wait until it shows "Flash Update Complete!".
5) Remove Memory stick and switch off and on again.
6) Update completed!
Warning) Do not remove memory stick during reading
and writing mermory stick in any cases.
[B]Improvements are:[/B]
- Fixed 'hang up' on zapping channels
- Fixed 'rebooting' on web interface
- Added EPG search menu
- Improved Plugin API
- Improved Teletext
- updated libcrypto.so.0.9.7
- Added 'Retrieve Internet IP' in menu