Code:
[B]How to do auto-update with ITGATE Control Center[/B]
New Control center must be used from now on.(from ver.2.4)
1) Download and Unzip the file below.
2) Run the ITGATE Control Center.
3) Insert & save IP address in the 'Config' section.
4) Press 'Update' button & select the *.img file in the 'Update' section.
5) Autoupdate will be started.
6) Wait until the receiver reboots automatically
[B]How to update TGS 210 by Flashing through serial port[/B]
New Control center must be used from now on.(from ver.2.4)
1) For Serial update, please click to download the image.
1. Connect the receiver & PC with RS 232 cable
2. Power on the receiver & press CH+ button on the front
at the same time repeatedly.
3. You will see the menu,in which there is 'Serial Update'
& go to the menu using by CH+/- button.
4. When you cursor located on 'Serial update', press vol+ button
& Press CH- button to start the upgrade.
-----------------------------------------------------
Before the above no.4,
1. run the control centre & go to the 'Serial update' section
(you don't need to input IP address)
2. After setup the com port, press 'file' & select the img.file.
After that, you can start the serial update under the above no.4
[B]How to update by Internet[/B]
1) Press MENU button on the remote controller and go into " Setup -> Expert
Setup -> Software Update -> Internet Update" and select the image.
2) Follow as prompted on the menu..
[B]Improvements are:[/B]
- Fixed 'hang up' on zapping channels
- Fixed 'rebooting' on web interface
- Added EPG search menu
- Improved Plugin API
- Improved Teletext
- updated libcrypto.so.0.9.7
- Added 'Retrieve Internet IP' in menu