MVision C4

MANUAL USB MVision C4

How to load the software for USB
Connect the decoder with the TV scart to visulizar tasks
on the monitor.
Select on the remote control:
Menu, utility, usb: in this screen Decoder pendrive or read the disk. In the
option to select the file upload (loqsea.ups) and give the OK of command;
then the screen will appear in a dialog titled "Selection
Mode ": Choosing" Update S / W "and agree with the ok
command. On the screen again you'll see a new dialog box in which
through bars will tell us the status of the usb reading and writing
in the flash. This process takes about 30 seconds and the deco restarts. Again
return to the above steps and select the file (loqsea.EXX) and
ok to give the command, the screen will appear in a dialog that will tell us
EXX that the file has been written successfully, we will give you the ok and will restart again. Already
since we last updated our decoder.


Loading channel list BY USB:
Menu, utility, usb: This screen will read the Decoder pendrive or hard drive; in
option to select the file upload (loqsea.SDB) and give the OK from
command, then the screen will appear in a dialog box that says "data
User channels filled with éxtito and give the command ok. The system is
restarted. We already have our list of channels introduced.

Loading SOFTCAM BY USB
Menu, utility, usb: This screen Decoder pendrive or read the disk, in the
option to select the file upload (SOFTCAM.) and give the OK from
command, then the screen will appear in a dialog box that says "LOAD
SUCCESS "we will give you the ok of command and our decoder and will be again
updated.



attached PDF in Spain