Could a pro please tell me if these configuration settings are correct for my 5400.
Macro mode on startup: On
Macro mode control button: TV/SAT
Symbolize +CAM activity: On
Display CI Window: On
AC/3 Burst installation: On
Check time on first channels: AU
Start on first channel: Off
Global Audio/Video PID: PMCT
Close channel list with Ok button: Off
Send DISEQC twice for cascade: On
Caid preselect: Card + Emu
Card blocker: Off
Sharing protocol mode: HSIC
I was also told to set the time at GMT+2.
Not sure if the TPS channel info is required.. France 5 = 2 hotbird, 10873, Vertical, 27500, 3/4 - Network search NO, Automatic Skip NO, LNB frequency NO, 0/12 Volt switch Enabled, Diseqc input Disabled, Motorised system Enabled, Video PID Auto, Audio PID Auto, PCR PID Auto.
Im wondering if ive uploaded the wrong settings or PMCT table.. before when in menu looking at Installation, Status, Signal detection, at the bottom it was Humax.NL or something and now its HumaxDream settings http://www.sat-universe.com/showthread.php?t=51597
Macro mode on startup: On
Macro mode control button: TV/SAT
Symbolize +CAM activity: On
Display CI Window: On
AC/3 Burst installation: On
Check time on first channels: AU
Start on first channel: Off
Global Audio/Video PID: PMCT
Close channel list with Ok button: Off
Send DISEQC twice for cascade: On
Caid preselect: Card + Emu
Card blocker: Off
Sharing protocol mode: HSIC
I was also told to set the time at GMT+2.
Not sure if the TPS channel info is required.. France 5 = 2 hotbird, 10873, Vertical, 27500, 3/4 - Network search NO, Automatic Skip NO, LNB frequency NO, 0/12 Volt switch Enabled, Diseqc input Disabled, Motorised system Enabled, Video PID Auto, Audio PID Auto, PCR PID Auto.
Im wondering if ive uploaded the wrong settings or PMCT table.. before when in menu looking at Installation, Status, Signal detection, at the bottom it was Humax.NL or something and now its HumaxDream settings http://www.sat-universe.com/showthread.php?t=51597
Last edited: