AllFlash_Reset_v13

*************************************************************
***************** AllFlash_Reset_v13.hdf ********************
*************************************************************

Upload this file to your Humax STB to reset all firmware,
settings & preferences Flash locations to FF
Use of this hdf file is needed only if you need to dump some Flash locations after
Never upload this file to your Humax if not really needed

AllFlash_Reset_v13.hdf has been tested on IRCI-5400 0016.0600

First of all you need to copy firmreset.rdd file into same folder where HDFSmart.exe is (
generally as default: C:\Program Files\HumaxSmartSuite\HDFSmart)
Run HDFSmart and select in menu: Config ---> Data Dictionary
Select firmreset.rdd
Quit HDFSmart

How to use AllFlash_Reset_v13.hdf:

1 - Turn your IRCI-5400 to standby mode

2 - Run HDFSmart and load AllFlash_Reset_v13.hdf

3 - Select all blocks, send them to STB and press "STANDBY" key in IRCI-5400

4 - Wait for ALL AllFlash_Reset_v13.hdf is uploaded and written to Flash
(it can take several minutes)

5 - When "End" is displayed, run HZU20 or HU15 or HDFSmart and load the firmware you like

6 - Check for correct firmware CRC or for errors or warning from HDFSmart

7 - Press "Upload (PC->STB)" key and press "STANDBY" key in your IRCI-5400

8 - When "End" is displayed, press "STANDBY" key in your IRCI-5400 and upload
settings channel list with your usual Settings Editor for Humax.
HNFSmart is suggested.


WARNING: we are not responsible for any possible damage to your Humax

Thanks to kaiman

Enjoy !


CrazySat