Problems VU+Duo Motor

T

t1ger

Registered
Messages
15
Hello,

I have problem with VU+Duo ! After install the imgage OpenPLI by USB, the pozitioner (Monteck) doesn't work when I change the channel !

I use the postioner setup, but the receiver doesnt storage the number which i wrote there !
 
Ferret

Ferret

Marching On Together !
Staff member
Administrator
Messages
17,533
Are you using usuals or manually storing the positions under diseqc 1.2? If the latter. You need to setup under advance and then turn on the lnb for all positions then scroll to the bottom and where it say use usuals select no then it will allow you to enter a position

Ferret
 
V

Vangeli

Registered
Messages
114
Ferret said:
Are you using usuals or manually storing the positions under diseqc 1.2? If the latter. You need to setup under advance and then turn on the lnb for all positions then scroll to the bottom and where it say use usuals select no then it will allow you to enter a position

Ferret
Click to expand...

It is important the number of the positions 001,002,003.... for hotbird,astra ....??????:confused:
 
Ferret

Ferret

Marching On Together !
Staff member
Administrator
Messages
17,533
No mate the position number you give the a satellite is not important.

For me though as i channel ho a lot i start at the far left of my arc say 45e and give that 001 then 42E 002 etc but it does not matter.

Ferret
 
You must log in or register to reply here.
Top