How to Program Omnia with Cas 3 (cas2/dynamite)
straight serial cable 9 pin with the correct ends needed
Please follow this steps in the order i m sugesting:
1. Open cas 3 by click the icon on your desktop
2. connect the usb cable, wait till program starts
3. go to untilities tab
4. click the phoenix mode
5. choice 3.579 mhz usally for pc, or 6 mhz for laptop
6. hide button
7. open the needed loader with glasses by double click it
8. in the loader window when opens correct the settings in com port,
tick the 6 mhz button only if need it, load the latest file where u saved
it.
9. Insert your card chip down & connect the serial cable
10. now click program
Shortly u will see the message "card program succesfully"
straight serial cable 9 pin with the correct ends needed
Please follow this steps in the order i m sugesting:
1. Open cas 3 by click the icon on your desktop
2. connect the usb cable, wait till program starts
3. go to untilities tab
4. click the phoenix mode
5. choice 3.579 mhz usally for pc, or 6 mhz for laptop
6. hide button
7. open the needed loader with glasses by double click it
8. in the loader window when opens correct the settings in com port,
tick the 6 mhz button only if need it, load the latest file where u saved
it.
9. Insert your card chip down & connect the serial cable
10. now click program
Shortly u will see the message "card program succesfully"