Program For NewCs server to Prevent Use More Than Ip To one user In the same Time
Magic NewCs
Download From here , Please Press Shift And Click left Mouse Key In the same time
http://www.megaone.com/magicnewcs
This tool for management NewCs server Programs for windows editions or lunix editions
Futures :
Connect to server with TCP port
Connect to server with Tcp command line
Control users – stop, active, reset data, add new users with on line mode
Block users which are use more than IP address
Block users which are use specific Emulator
Block users which are connect from specific IP address
Determine users channels
Determine number of Ok Ecm, bad Ecm, Emm
Determine number of online users
Determine number of sockets users are use
Determine number of connections are open in specific duration
Determine max hits from Ip That Make Load To server (prevent hack to server)
control server from any where
instillation :
you can use setup file to install the program to windows operating system , and you must be enable in your server debugging mode by adding in newcs.xml file then lines , configuring your password and port number to which are use it to connect with server ,
add these line to newcs.xml file
<debug>
<password>YourPassWord</password>
<level>normal</level>
<type>all</type>
<output>all</output>
<console_options>normal,init</console_options>
<logfile></logfile>
<file_options>normal,all</file_options>
<udp_host>0.0.0.0</udp_host>
<udp_port>1000</udp_port>
<udp_options>normal,all</udp_options>
<tcp_port>34534</tcp_port>
<tcp_options>normal,all</tcp_options>
</debug>
This program tested with newcs server version "NEWCS12RC13"
License :
This program is free from 01/02/2007 until 14/02/2007 but you must connect to the internet while you use it
Please Read the readme.txt file
Magic NewCs
Download From here , Please Press Shift And Click left Mouse Key In the same time
http://www.megaone.com/magicnewcs
This tool for management NewCs server Programs for windows editions or lunix editions
Futures :
Connect to server with TCP port
Connect to server with Tcp command line
Control users – stop, active, reset data, add new users with on line mode
Block users which are use more than IP address
Block users which are use specific Emulator
Block users which are connect from specific IP address
Determine users channels
Determine number of Ok Ecm, bad Ecm, Emm
Determine number of online users
Determine number of sockets users are use
Determine number of connections are open in specific duration
Determine max hits from Ip That Make Load To server (prevent hack to server)
control server from any where
instillation :
you can use setup file to install the program to windows operating system , and you must be enable in your server debugging mode by adding in newcs.xml file then lines , configuring your password and port number to which are use it to connect with server ,
add these line to newcs.xml file
<debug>
<password>YourPassWord</password>
<level>normal</level>
<type>all</type>
<output>all</output>
<console_options>normal,init</console_options>
<logfile></logfile>
<file_options>normal,all</file_options>
<udp_host>0.0.0.0</udp_host>
<udp_port>1000</udp_port>
<udp_options>normal,all</udp_options>
<tcp_port>34534</tcp_port>
<tcp_options>normal,all</tcp_options>
</debug>
This program tested with newcs server version "NEWCS12RC13"
License :
This program is free from 01/02/2007 until 14/02/2007 but you must connect to the internet while you use it
Please Read the readme.txt file