I've been tested oscam.sh4 published by @ElGeneral ... but I've
had some surprises !
- the STB started with RedCam ... I stopped RedCam ... replaced
RedCam with oscam.sh4 ( svn4821 @ElGeneral ) ...start Oscam and
works perfectly !
- I switch off the STB and start again Oscam ... surprize ! he
starts but does not decode anything ! probably is some config
to do in [stapi] ... config made automaticaly by RedCam !
@ElGeneral --- could you exemplify the sollution ?
Tests were made on Octagon 1008 ( Optibox Koala HD ) with last FW !
I cannot use furthermore RedCam because at the last versions the
guys from RedCam are doing some identity test ( only Octagon !!! )
as RedCam is completly original ! their own ! tnks guys ... good manner !
had some surprises !
- the STB started with RedCam ... I stopped RedCam ... replaced
RedCam with oscam.sh4 ( svn4821 @ElGeneral ) ...start Oscam and
works perfectly !
- I switch off the STB and start again Oscam ... surprize ! he
starts but does not decode anything ! probably is some config
to do in [stapi] ... config made automaticaly by RedCam !
@ElGeneral --- could you exemplify the sollution ?
Tests were made on Octagon 1008 ( Optibox Koala HD ) with last FW !
I cannot use furthermore RedCam because at the last versions the
guys from RedCam are doing some identity test ( only Octagon !!! )
as RedCam is completly original ! their own ! tnks guys ... good manner !
Last edited: