You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Firmware 5000c 190p stops decoding
- Thread starter henkie12
- Start date
Installed 190p for 5000C and it works almost great.
Emu is no problem.
BUT...every few hours the firmware just stops decoding. :mecry:
Switching back and forth on a channel will restart decoding again.
Tried to go to factory settings to no avail.
Anyone?
Ronald
repeat all again, load the 190 and power off, turning off the receiver from the back button, then refresh settings and softcam